Rubber parking bumpers

Heavy traffic in parking lots, logistics and warehouse complexes creates increased stress on the enclosing structures. Walls, columns and corners are regularly subjected to mechanical shocks during parking, maneuvering or opening car doors. An effective solution to this problem is the use of rubber bumpers to protect walls and corners .

Why are bumpers needed in parking lots?

Safety systems perform several important functions at once. They protect the wall covering from chips, cracks and dirt, preserving the aesthetic appearance of the room. At the same time, bumpers minimize the risk of damage to the car in contact with a wall or column. This is especially important for facilities with limited space, where the safe distance between vehicles is significantly reduced.

The use ofshock-absorbing rubber bumpers allows you to significantly increase the service life of the building without the need for frequent repairs, which reduces the costs of the owner of the facility.

Design and principle of operation

Parking bumpers are made of durable hard rubber and are equipped with reflective yellow signal inserts. The internal design provides for the presence of cavities that absorb some of the energy upon impact. Due to this, the force of the collision is significantly reduced, and the bumper works as an effective damper.

Reflective elements are highly visible even in low light, which increases traffic safety and helps the driver navigate during maneuvers.

Main types of bumpers

Different models are used for different zones:

wall bumpers (RG 100, RG 150, RG 200) - for protecting flat surfaces along driveways;
corner bumpers (RG 80) - for columns, corners and protruding structures.

For example, the RG 150 wall bumper is 150 mm wide, 3 m long and 20 mm thick, making it optimal for intensively used parking lots and warehouse areas.

Installation and operation

The bumpers are installed using dowels and screws with a recommended mounting pitch of 40–50 cm. Before fixing, the reflective inserts are removed, and after fixing the product, they are installed back into special grooves. The optimal mounting height of wall bumpers is 65–70 cm from the floor level .

The bumpers are suitable for both indoor and outdoor parking lots. They are resistant to ultraviolet radiation, do not lose elasticity at low temperatures and do not damage the car's paintwork upon contact.

Why choose parking lot bumpers from Protex?

Modernwall and corner protection bumpers are a practical and cost-effective solution for commercial and industrial facilities. They provide long-term structural protection, increase traffic safety and help avoid unexpected repair costs.

Protex offers reliable safety systems for parking lots and warehouse complexes that meet modern operational and safety requirements.